- 優道三元催化還原修復劑 汽車尾氣治理
-
優道三元催化還原修復劑 （汽車尾氣治理）采用濃縮型的超分子技術，能很好地去除三元催化器上的硫、鉛、磷、鋅等化學物質。本產品由美國ubrizol-UD、美國陶氏公司提供原料原料及技術支持，扎根中國汽車養護用品研發一級學府--華南理工大學化工系，精心研發而成！
保養時間：20000-30000公里
優道三元催化還原修復劑
產品編號：UD-118/480ML
企業標準：Q/YK 012-2009
產品僅供4S店使用
產品性能
1、高效分解三元催化、氧傳感器上的硫、鉛、磷、鋅等化學物質。
2、重新激活三元催化器中鉑、銠、鈀的凈化功能，大幅降低汽車尾氣中CO、HC、NOX的排放。
3、提升燃油燃燒效率，提高冷車啟動性能，恢復汽車原有動力，降低油耗。
4、延長三元催化器及氧傳器的使用壽命，減少維護綜合成本。
使用方法
1：起動汽車發動機至正常工作溫度。
2：用專用油門固定器，將引擎轉速固定在2500轉。
3：尋找、拆開節氣門后的真空管（有真空吸力）。靠近節氣門第一個管口最佳。
4：把產品瓶口打開連接在專用的清洗設備上，并把設備出液透明軟管與汽車的真空管對接。
5：打開設備開關，將流量調整開關調到20-30分鐘的清洗時間最佳，檢視產品形成泡沫進入真空管為正確除碳工作狀態。
6：除碳時進氣岐管由熱轉冰涼是最佳有效狀態，除碳完成后15分鐘，拔出連接產品瓶口端的管口。
7：待進氣岐管由冰涼轉熱（用手摸進氣岐管最底部確認），引擎恢復正常工作溫度后進行排碳動作。
8：將油門固定器拆下，以每500轉/10秒輕緩加油，逐次加至3000轉；以稍快速度重復上述動作；待進排氣聲順暢時，再拆開除碳元素接管，恢復原車接管，除碳中及排碳時絕不可以重踩油門。排碳后路試。
以下幾種情況不能清洗：
1.三元催化器燒結或鉛中毒；
2.三元催化器嚴重堵塞；
3.化油器車改裝為三元；
4.發動機燒機油。
清洗完畢后車輛需要行駛5公里左右以便廢物排出。
注意事項
1.禁止將本品直接加入油箱與汽油混合使用；
2.勿將本品濺入眼內，如不慎濺入眼中立即用清水沖洗，再去醫院治療；
3.存放陰涼干燥處，避免兒童接觸。
Air System Maintenance Agent
Features:
1st, decomposes three Yuan catalyzed, oxygen chemical substances highly effective and so in sensor's sulfur, lead, phosphorus, zinc.
2nd, activates in three Yuan catalysts the platinum, the rhodium, the arrowhead purification function, restores three Yuan catalyst original performance. Reduces in largely the automobile exhaust CO, HC, the NOX emissions.
3rd, the promotion oil inflame efficiency, enhances the refrigerated car starting ability, restores the automobile original power, reduces the oil consumption.
4th, lengthens three Yuan catalysts and the oxygen pass on service life, reduces the maintenance comprehensive cost.
Use Method
1: Starting motor car engine to normal work temperature.
2: With the special-purpose accelerator anchor, fixes the speed by engine revs in 2500 revolutions.
3: After seeking for, disassembles the damper the vacuum tube (to have vacuum suction). Approaches a solar terms family status orifice to be best.
4: Opens the connection the product bottle mouth on the special-purpose decontaminatin unit, and leaves the equipment the fluid transparent hose and automobile's vacuum tube docking.
5: Turns on the equipment switch, adjusts the current capacity adjustment switch to 20-30 minute scavenging periods is best, inspected that the product forms the froth to enter the vacuum tube for the correct decarbonizing active status.
6: Decarbonizes when the intake manifold by the hot extension icy cold is the best effective condition, after decarbonizing completes, 15 minutes, draws out the connection product bottle mouth end the orifice.
7: Waits the intake manifold hot (to trace intake manifold most base confirmation by the icy cold extension with hand), after engine rehabilitation temperature, carries on the row of carbon movement.
8: Dismantles the accelerator anchor, refuels leisurely by every 500 revolution of /10 seconds, adds gradually to 3000 revolutions; Is redundant above movement by the slightly quick speed; Treats when the exhaust sound is smooth, again disassembles decarbonizes the element control, recovers extensively the vehicle control, decarbonizes and when a row of carbon may not step on the accelerator again. After arranging the carbon, driving test.
The following several kind of situations cannot clean:
1.3 Yuan catalyst agglutinations or lead poisoning;
2.3 Yuan catalysts stop up seriously;
3. the carburetor vehicle re-equipping is three Yuan;
4. the engine burns the machine oil.
After the clean finished, the vehicles needed to go about 5 kilometers, so that the waste could discharge.
Note:
1、forbid to join directly in the fuel tank and the gasoline mix use;
2、This is the combustible materials, when the use should be far away from the high temperature area and the open fire, depositing cool dry place;
3、This swallows harmfully, is sure not the entrance, is far away from the child.
招商電話:13318861726
客服電話:400-6628285
車境界高新材料科技(廣州）有限公司專業從事汽車快修、護理、快保、養護、涂料等業務。主要生產發動機、無水冷卻液，汽車油漆，空調清洗劑，汽車美容用品，汽車積碳清洗劑等產品。擁有專業的研發隊伍，可進行汽車用品批發和代理。
?車境界汽車養護 All Rights Reserved. ???粵ICP備09135005號-1
